Powering on and connecting your system

Modified on Mon, 15 May, 2023 at 7:16 PM

After setting up your tripods, to setup your system,  place your gates in the same vicinity (within a few feet of each other and the iPad). 

Hold the button on the front of the gates, you will hear a *beep*, release the button and the gate strobe will turn green, and then flash white.

The system is now ready for you to connect to it using the the Syncro App.

On your iPad, under 'Run Test' select a test you wish to run. The Syncro App will now find the gates and request to join the gates as a Wifi Network. 

Only select a test compatible with your system, if not you wont be able to connect.

While gates are connecting the strobes will turn orange.

Select 'Join Network', syncro will then assign the gates colours and they will 'breathe'.

Once connected you can follow on screen instructions and begin gate Alignment.

Gate colours as seen in the syncro setup page represent the same colours of the gates in the field.

Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article